Home >
NE2-D11A RS485 to Ethernet Serial Server Modbus Gateway Supports TCP/UDP/MQTT/HTTP protocols

[Introduction]:NE2-D11A single serial port server is used to realize bidirectional transparent transmission of data from RS485 serial port to Ethernet port. It has multiple Modbus gateway modes and MQTTC/HTTPC IoT gateway modes, which can meet the networking functions of various serial port devices/PLCs; it adopts industrial-grade design standards to ensure equipment reliability. The serial port server realizes transparent transmission of serial port data to Ethernet TCP/IP data packets. Users do not need to care about the specific details, and the protocol conversion is completed inside the device.

PIN
serial numbernameFunctionillustrate
1POWERPower indicator light (blue)Steady on: power on; Steady off: power off
2TXDSerial port sending indicator light (red)Flashing: The serial port outputs data to the customer device
3RXDSerial port receiving indicator light (green)Flashing: The customer device outputs data to the NE2-D11 serial port
4M0Link indicator (green)Flashing: The network cable is connected normally but the link is not connected; On: The network link is connected successfully
5M1Network negotiation indicator light (red and green)Off: The network cable is not connected
Green light: indicates 100M network; green light: data interaction at the physical layer
Red light: indicates 10M network; red light: data interaction at the physical layer
6RELOADFactory reset buttonPress and hold for 5-10S. All indicators on the device will light up, indicating that the device has been restored to factory settings.
7EthernetNetwork portStandard RJ45 interface, 10/100M cross-direct connection adaptive
8Ggroundsignal ground
9A/TXDA/TXDConnect to RS485-A or RS232-RXD
10B/RXDB/RXDConnect to RS485-B or RS232-TXD
11LAC 85~265V input2P 5.08mm terminal block
12N